- Apply long side at right angle to framing. Support in assistant's hand hold up ceiling board during nailing.
- Assistant starts to support the ceiling board as it is carefully edged into place.
- First nail driven into center of sheet; then nail outward to opposite edge.
- Left hand holds board against joists while nailing. Nails always "dimple" the surface.
- No saw is needed.Score both faces of the board with a hooked knife and snap off.
- Scrap pieces can be used in small areas like the section around a window show above.
- Board is punctured with saw tip, then cut to provide opening for recessed light fixture.
- Board knife is used to spread joint cement. It is first step in joint-concealment procedure.
- Reinforcing tape is applied over cement to entire length of joint and pressed into place.
- After excess cement is removed, wait a day. Apply second coat wider then first.
- Fine sandpaper, used with minimum of pressure, helps smooth the surface.
10.24.2011
APPLYING GYPSUM WALLBOARD
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment